Two-stage revision arthroplasty for PJI may make use of an antibiotic-loaded cement spacer (ACS), as successful long- term prevention of reinfection have been reported using this technique.[i] However, there is little data on systemic complications of high-dose antibiotic spacers. Acute kidney injury (AKI) is of clinical significance, as the drugs most commonly utilized, vancomycin and aminoglycosides, can be nephrotoxic. We intended to determine the incidence of AKI in patients that underwent staged revision arthroplasty with an ACS, as well as to identify potential predisposing risk factors for the disease. Local databases of six different orthopaedic surgeons were retrospectively reviewed for insertion of either a static or articulating antibiotic cement spacer by from 2007–2017. Dose of antibiotic powder implanted, as well as IV antibiotic used, was collected from operative records. Demographics, comorbidities, and preoperative and postoperative creatinine and hemoglobin values were recorded from the EHR. AKI was defined by a more than 50% rise in serum creatinine from preoperative baseline to at least 1.4 mg/dL, as described by Menge et al.[ii] Variables were analyzed for the primary outcome of AKI within the same hospital stay as insertion of the ACS. Categorical variables were analyzed with Chi-Square test, and continuous variables with univariate logistic regression.INTRO
METHODS
This study aims to identify recent trends in discharge disposition following bilateral total knee arthroplasty (TKA) as well as factors that predispose patients to enter inpatient rehabilitation facilities (IRF) or skilled nursing facilities (SNF) versus home-rehabilitation (HR). The goal was to identify risk factors that predispose prolonged hospital stays and identify changes in management over time that may be responsible for decreased length of stay (LOS) and a HR program. A retrospective cohort study design was used to collect and analyze clinical and demographic data for 404 consecutive bilateral primary total knee arthroplasty (TKA) procedures. Patients who underwent elective primary bilateral total knee arthroplasty from 2011 to 2016 were identified from hospital records at a single institution. Clinical and demographic data including sex, age, and disposition were analyzedBACKGROUND
METHODS
High-dose antibiotic cement spacers are commonly used to treat prosthetic joint infections following knee arthroplasties. Several clinical studies have shown a high success rate with antibiotic cement spacers, however there is little data on the systemic complications of high-dose antibiotic spacers, particularly acute kidney injury (AKI). This study aims to determine the incidence of AKI and identify risk factors predisposing patients undergoing staged revision arthroplasty with antibiotic cement spacers. A single-institution, retrospective review was used to collect and analyze clinical and demographic data for patients who underwent staged revision total knee arthroplasty with placement of an antibiotic-impregnated cement spacer from 2006 to 2016. A search was made through specific procedure (DRG) and diagnostic (CD) codes. Baseline descriptive data were collected for all patients including age, sex, medical comorbidities, type and quantity of antibiotics used in the cement spacer, pre- and postoperative hemoglobin (Hg), BMI, smoking status, peak creatinine levels, and random vancomycin levels. Acute kidney injury was defined as a more than 50% rise in serum creatinine from a preoperative baseline within 90 days postoperatively.BACKGROUND
METHODS
There is renewed concern surrounding the potential for corrosion at the modular head-neck junction to cause early failure in modern hip implants. Although taper corrosion involves a complex interplay of many factors, previous studies have correlated decreasing flexural rigidity of the femoral trunnion with an increased likelihood of corrosion at retrieval. A multicenter retrieval analysis of 85 modular femoral stems was performed to calculate the flexural rigidity of various femoral trunnions. Stems were implanted between 1991–2012 and retrieved between 2004–2012. There were 10 different taper designs from 16 manufacturers. Digital calipers were used to measure taper geometries by two independent observers. Mean flexural rigidity was 262 Nm2, however there was a wide range of values among the various stems spanning nearly an order of magnitude between the most flexible (80 Nm2) and most rigid (623 Nm2) trunnions, which was due in part to the taper geometry and in part to the material properties of the base alloy. There was a modest but significant negative correlation between flexural rigidity of the trunnion and release date of the stem. This wide variability in flexural rigidity may predispose particular stem designs to an increased risk of corrosion at the modular head-neck taper, and may in part explain why taper corrosion is being seen with increasing frequency in modern hip arthroplasty.
Advances in the performance and longevity of total joint arthroplasty (TJA) have been enabled by related progress in implant materials, device designs, and surgical techniques. Successful TJA also depends upon adequate bone quality to provide an enduring mechanical foundation. Bone quality can be defined as the ability to repetitively withstand physiologically-relevant loads without excess deformation or fracture. It is now recognized that bone quality encompasses more than just material quantity, i.e. densitometrically-measured bone mass. Bone quality is also determined by: material composition and arrangement, cortical and cancellous structure, and extent of microdamage. These properties, together with the appropriate mass, confer bone with the biomechanical competence needed to meet the repetitive load-bearing demands imposed by total joint implants. The need for TJA continues to increase in the aging global baby-boomer population. Unfortunately, this group is also experiencing increases in related comorbidities including: osteoporosis, kidney dysfunction, and diabetes, among others. Collectively these three comorbidities afflict more than 74 million Americans, and each is increasing at 2–8% annually. More importantly, each of these comorbidities negatively affects bone quality through alterations in bone turnover independent of bone mass changes commonly associated with these diseases. Specifically, alterations in bone turnover result in abnormal mineral-to-matrix ratios as measured by Fourier transform infra-red (FTIR) spectroscopy (Fig. 1) and altered Young's moduli (shape-independent resistance to deformation) as measured by nanoindentation (Fig. 2). These parameters are related to bones' fracture toughness and load-bearing capabilities, respectively. Also, low bone turnover is associated with mechanically important structural changes, i.e., decreased trabecular thickness (Fig. 3), cortical thickness and cancellous volume. Furthermore, low bone turnover may result in reducing the repair rate of physiologically – induced bone microdamage. This may lead to increases in the number or length of bone cracks, crack coalescence, and ultimately reduced energy needed for fracture. Therefore, patients needing TJA who also have comorbidities associated with abnormal bone quality are at risk for inferior arthroplasty results. Recognition and treatment of the TJA-relevant biomechanical implications of these comorbidities may help improve outcomes.
Supracondylar fractures of the humerus have historically been treated as an emergency case and operated on at the earliest opportunity. We undertook a study to examine whether surgical timing affects the need for open reduction or peri-operative complications in the type III injuries. Between August 1995 and August 2004, 534 patients presented and were referred to our unit with these fractures. Those with closed, type III injuries without vascular compromise were selected (171 patients). These were divided into 2 groups: those undergoing surgery less than 8 hours from presentation (126 patients) and those undergoing surgery more than 8 hours from presentation (45 patients). The two major differences between the two groups were: the delayed group were more likely to undergo open reduction (33.3% v 11.2%, p<0.05) and the mean length of the surgical procedure was increased (105.1 minutes v 69.2 minutes, p<0.05). Delay in treatment of the type III supracondylar fractures is associated with an increased need for open reduction and a longer procedure. We would recommend treating these injuries at the earliest opportunity.
This study investigates the experience of one treatment centre with routine surveillance MRI following excision of sarcoma. Casenotes, MRI and histology reports for fifty-nine patients were reviewed. The primary outcome was the presence of local tumour recurrence and whether this was identified on surveillance or interval scanning. Forty-eight patients had a diagnosis of soft tissue sarcoma, the remaining 11 a primary bone tumour. Fifteen patients had local recurrence (25%). Eight were identified on surveillance scan, and the remaining 7 required interval scans. Surveillance scanning has a role in the early detection of local recurrence of bone and soft tissue sarcoma.
