header advert
Results 1 - 3 of 3
Results per page:
Orthopaedic Proceedings
Vol. 100-B, Issue SUPP_7 | Pages 20 - 20
1 May 2018
Bonner T Masouros S Newell N Ramasamy A Hill A West A Clasper J Bull A
Full Access

The lower limbs of vehicle occupants are vulnerable to severe injuries during under vehicle explosions. Understanding the injury mechanism and causality of injury severity could aid in developing better protection. Therefore, we tested three different knee positions in standing occupants (standing, knee in hyper-extension, knee flexed at 20˚) of a simulated under‐vehicle explosion using cadaveric limbs in a traumatic blast injury simulator; the hypothesis was that occupant posture would affect injury severity.

Skeletal injuries were minimal in the cadaveric limbs with the knees flexed at 20˚. Severe, impairing injuries were observed in the foot of standing and hyper‐extended specimens. Strain gauge measurements taken from the lateral calcaneus in the standing and hyper-extended positions were more than double the strain found in specimens with the knee flexed position. The results in this study demonstrate that a vehicle occupant whose posture incorporates knee flexion at the time of an under‐vehicle explosion is likely to reduce the severity of lower limb injuries, when compared to a knee extended position.


Orthopaedic Proceedings
Vol. 95-B, Issue SUPP_26 | Pages 16 - 16
1 Jun 2013
Bonner T Newell N Pullen A Bull A Masouros S
Full Access

Characterising material properties of ligaments is essential in the analysis of human morbidity and mortality of low-speed sporting accidents, high-speed road traffic accidents, and very high-speed battlefield injuries. At lower strain rates the elastic modulus and ultimate stress increase relative to strain rate, although very high strain rate testing has not been performed to date.

A porcine stifle joint lateral collateral ligament experiment was conducted that simulated the strain rates that occur during across a full range of different human knee ligament injuries. Tensile testing was performed at five strain rates, each an order of magnitude apart, in the range 100–104%/s. Seven specimens were tested at each rate. Three loading techniques were used: 1) screw-driven, 2) servo-hydraulic, 3) drop weight rig with tensile impact adaptor. Cross sectional area was measured by counting pixels on a standardized digital photograph of an alginate-paste cast of the mid-substance of each sample. Strain was measured directly from the mid-substance of each ligament by high-speed video extensometry. Stress-strain curves were produced and used to quantify the elastic modulus, failure strain and ultimate stress at each strain rate.

Across the range of strain rates, elastic modulus increased from 288 to 905 MPa (p< 0.05), and ultimate stress increased from 39.9 to 77.3 MPa (p< 0.05). A relationship between strain rate and both, elastic modulus and ultimate stress was identified. Strain rate sensitivity was not observed at very fast strain rates.

Ligament strength increases when strain rates are high. These data provide an explanation for very high strain rate failure of ligaments under extreme loading conditions, that can be considered protective of bone fracture, such as can be seen in traumatic through knee amputations in blast injuries.


Orthopaedic Proceedings
Vol. 94-B, Issue SUPP_XXXII | Pages 3 - 3
1 Jul 2012
Bonner T Eardley W Newell N Masouros S Gibb I Matthews J Clasper J
Full Access

Circumferential pelvic binders have been developed to allow rapid closure of the pelvic ring in unstable fracture patterns. Despite evidence to support the use of pelvic binders, there is a paucity of clinical data regarding the effect of binder position on symphyseal diastasis reduction.

All patients presenting to the UK's military hospital in Afghanistan who survived and underwent pelvic radiography were reviewed. Cases were identified by retrospective assessment of all digital plain pelvic radiographs performed between January 2008 and July 2010. All radiographs and CT images were assessed to identify the presence of any pelvic fracture. Patients were grouped into three categories according to the vertical level of the buckle: superior to the trochanters (high), inferior to the trochanters (low) and at the level of the trochanters (troch). Diastasis reduction was measured in patients with Anterior-Posterior Compression (APC) grades II and III, or Combined Mechanical Injuries(CMI). Comparison of diastasis reduction between the high and troch groups was assessed by an independent samples Student's t-test.

We identified 172 radiographs where the metallic springs in the buckle of a SAM Pelvic Sling were clearly visible. The binders were positioned at the trochanteric level in 50% of radiographs. A high position was the commonest site of inaccurate placement (37%). In the patients with fractures and an open diastasis, the mean pelvic diastasis gap was 2.75 times greater in the high group compared to the trochanteric level (mean difference 22 mm) (p < 0.01).

Application of pelvic binders superior to the greater trochanters is commonplace and associated with inadequate fracture reduction, which is likely to delay cardiovascular recovery in these significantly injured casualties.