Abstract
Thigh-calf contact force is the force acting on posterior side of the thigh and calf during deep knee flexion. It has been reported the force is important to analyze the kinetics of a lower limb and a knee joint. Some previous researches reported the measured thigh-calf contact force, however, the values varied among the reports. Furthermore, the reports indicated that there were large variations even in a single report. One of the reports tried to find the relationship between the magnitude of thigh-calf contact force and anthropometric measurement as height, weight or perimeter of the lower limb, however, there could not found clear correlations. We considered that the cause of the variations might be the difference of the posture. At heel-rise squatting posture, we can bend or stand upright the upper body. Therefore we tried to create the equation to estimate the thigh-calf contact force by multiple regression analysis, using the anthropometric and posture parameters as explanatory variables.
We performed the experiment to measure thigh-calf contact force, joint angles and anthropometric information. Test subjects were 10 healthy male. First we measured their height, weight, perimeter of the thigh and muscle mass of the legs and whole body. Muscle mass was measured by body composition meter (BC-118E, Tanita Co., Japan). Then, test subjects were asked to squat with their heels lifted and with putting the pressure distribution sensor between thigh and calf. And they bent their upper body forward and backward. The pressure sensor to be used was ConfroMat System (Nitta Co., Japan). After that, we measured the joint angles of the hip, knee and ankle, and the angle between the floor and upper body using the videos taken during the experiment. Then, we created the equation to estimate the thigh-calf contact force by linear combination of the anthropometric values and joint angles. The coefficients were settled as to minimize the average error between measured and estimated values.
Results are shown in Fig.1. Forces were normalized by the body weight of the test subjects. Because the horizontal axes show the measured and vertical axis show the estimated values, the estimation is accurate when the plots are near the 45-degree line. Average error was 0.11BW by using only physical values, 0.15BW by angles and 0.06BW using both values. And the maximum error was 0.69BW, 0.43BW and 0.32BW respectively. Thus we could estimate the thigh-calf contact force by multiple regressions, using both physical parameters and angles to indicate the posture. Using the equation, we would be able to analyze the kinetics of a lower limb by physical and motion measurement. Our future work might be increasing the number of subjects to consider the appropriateness, because the test subjects of this study were very limited.
