Abstract
Introduction
Patient specific surgical guide (PSSG) is a relatively new technique for accurate total knee arthroplasty (TKA), and there are many reports supporting PSSG can reduce the rate of outlier in the coronal plane. We began to use PSSG provided by Biomet (Signature®) and have reported the same results. Before using Signature, we performed TKA by modified gap technique (parallel cut technique) to get the well balanced flexion gap. Signature is the one of the measured resection technique using the anatomical landmarks as reference points on the images of CT or MR taken before surgery. We usually measure the center gap width and gap balance during operation with the special device “knee balancer”(Fig. 1) that can be used on patella reposition. After cutting all of the bone with Signature, gap balance in the extension position was very good but the gap balance was shown slight lateral opening in the 90 degrees flexion position. So we have changed the surgical procedure. We use Signature for cutting only distal femur and proximal tibia to get extension gap and apply the modified gap technique to decide the rotation of the femoral component (Signature with modified gap technique).
The purpose of this study is to compare the gap balance between the two techniques.
Materials & Methods
From November, 2012 through March, 2014, 50 CR type TKA (Vanguard Knee®, Biomet) in osteoarthritis patients were performed using Signature. 25 TKA were performed using only Signature (group S) and other 25 TKA were done using Signature with modified gap technique (group SG). After all osteotomies of femur and tibia were completed, applying femoral trial, center gap width and gap balance (plus means lateral opening angle) were measured using knee balancer with respect to 30 degrees of the knee flexion angle from zero to 120 degrees (Fig. 2).
Results
From knee flexion angle 0 to 120 degrees, gap width was 10.8, 11.9, 11.3, 11, 2 10.8mm in group S, 11.9, 12.6, 11.9, 12.0, 11.8mm in group SG, the range of the gap width was small, 1.1mm and 0.8mm. Gap balance was 0.4, 0.6, 1.0, 2.6, 3.6 degrees in group S and 0.1, 0.1, 0.5, 0.6, 2.6 degrees in group SG.
Discussion
With both techniques, Signature and Signature with gap technique, center gap width stayed constant. When it comes to gap balance, in Signature with gap technique group, gap balance were good and constant in knee flexion angle from zero to 90 degrees. But in Signature group, the more flexion angle increased, the more lateral opening angle enlarged. So Signature with gap technique is better than only Signature to get good gap balances during knee movement.
