Abstract
Ceramic bearings are currently the most widely used alternative to metal-on-polyethylene bearings in total hip arthroplasty (THA). A workgroup at International Consensus Meeting (ICM) analyzed the potential link between the type of bearing surface and the subsequent periprosthetic joint infection (PJI), and found a higher incidence of PJI when using a metal-on-metal (MoM) bearing surface. A potential reason is that the failure of a MoM bearing surface can result in adverse local tissue reactions (ALTR), which might provide a favorable environment for bacterial proliferation.
In the last few years, several observational studies including national registries, showed that metal-on-polyethylene (MoP) bearing surfaces are associated with a higher rate of infection following total hip arthroplasty (THA) compared to ceramic bearings, in particular with the use of ceramic-on-ceramic bearing (CoC) surfaces.
After adjusting for selection bias and various confounding factors, patients treated with ceramic bearings experienced reduced risk of infection and MoP bearing surface is an independent risk factor correlating with higher incidence of PJI. The meta-analysis by Lee et al. comparing MoM with CoC cementless THA confirmed that the MoM is associated with a significantly higher revision rate than CoC group for any reason as well as for PJI. Furthermore, initial in-vitro studies have shown lower bacterial biofilm formation on ceramic bearing surfaces. Summarizing the current literature, ceramic bearings are associated with a lower risk of infection following THA.
