Abstract
Both gap balancing and measured resection for TKA will work and these techniques are often combined in TKA. The only difference is really the workflow. The essential difference in gap balancing is that you determine femoral component rotation by cutting the distal femur and the proximal tibia, and then using a spacer to determine femoral rotation.
I prefer measured resection because I am, for most cases, a cruciate retaining surgeon. It is not ideal to determine femoral rotation based upon a gap balancing if you retain the cruciate. It is also important to maintain the joint line, especially in cruciate retention, in order to reproduce more normal kinematics and balance the knee throughout the range of flexion and extension. It is my opinion that the soft tissue balancing is easier to do with measured resection and the workflow is easier.
The sequence of cuts and soft tissue balance is different if one is a gap balancing surgeon. This is more conducive for people who are cruciate substituters, but more difficult in a varus cruciate retaining knee. In that situation, if you determine femoral rotation by gap balancing with the tibia before you have cleared the posterior medial osteophytes in the varus knee, and remove the last bit of meniscus, you could artificially over rotate the femoral component causing posteromedial laxity. The major difference is that cutting the posterior cruciate will open the flexion space and allow the surgeon easier access to the posteromedial corner of the knee before the posterior femoral cut is made. It is also important to remember that in most cases cruciate substitution surgeons will make the flexion space 2 mm smaller than the extension space to compensate for the flexion space opening when the posterior cruciate is cut. The extensor mechanism plays an important role in flexion balance and should only be tested once the patella is prepared and the patella is back in the trochlear groove. I prefer gap balancing in most revision knees as I am virtually always substituting for the posterior cruciate in that case.
My technique for measured resection is to assess the character of the knee prior to surgery. Is it varus? Is it valgus? Does it hyperextend? Does it have a flexion contracture? Would the knee be considered tight or loose? I cut the distal femur first, based upon measured resection. I use anatomic landmarks to determine femoral rotation. My most consistent landmark is the transtrochlear line, which is not always from the top of the notch to the bottom of the trochlea. I will use the medial epicondyle and the posterior reference in a varus knee, but not in a valgus knee.
The tibial cut, also by measured resection, is easier once the femur has been prepared. The patellar cut is also a measured resection. Having done a preliminary soft tissue balance based upon the deformity, I will then use trial components to finish the soft tissue balance.
In summary, both techniques can be used successfully in a cruciate substituting knee, but measured resection, in my opinion, is preferable especially in varus arthritis when the posterior cruciate is retained
