FINITE ELEMENT ANALYSIS OF SQUEAKING HIPS

Abstract

Introduction: Squeaking is reported ceramic-on-ceramic hip bearings in association with acetabular component malposition – particularly too much or too little anteversion. Acoustic analysis of squeaking hips with modular ceramic-titanium acetabular components suggests that there may be dynamic uncoupling of the ceramic insert from the titanium shell with edge loading of the ceramic. The aim of this study was to investigate edge loading of a modular ceramic-titanium acetabular component during gait at different positions of anteversion using the finite element (FE) method.

Methods: An intact and reconstructed 3D FE model of a human pelvis was generated using PATRAN. Bone properties extracted from the CT data were applied using FORTRAN subroutines. A generic acetabular titanium shell and ceramic liner were modelled and placed in the pelvis in two different positions: ideal anteversion and 18 degree excess anteversion. The contact conditions simulated a fully osseointegrated acetabular shell and a matched taper junction with a friction coefficient of 0.2. We ran FE analysis with ABAQUS software to determine the stress distribution and surface separation of shell and liner at toe-off.

Results: The separation distance between the ceramic liner and the acetabular shell for the anteverted component (40mm) was an order of magnitude greater than that for the ideally positioned component (4mm). There was “tilting” of the ceramic liner out of the acetabular shell in both cases.

Discussion: Based on clinical observations, the toe-of phase of gait is a common position for squeaking to occur. Clinical retrievals also show evidence of edge loading wear and contralateral taper interface separation with the “tilting” of the liner out of the acetabular shell. It is envisaged that the “tilting” of the liner in the acetabular shell may allow forced vibrations associated with the squeaking phenomena, possibly in combination with edge loading.