Abstract
Purpose of the study: To determine if cement type, bone mineral density (BMD), disc degeneration and fracture severity influence the restoration of spinal load-sharing following vertebroplasty.
Methods: Fifteen pairs of thoracolumbar motion-segments (51–91 yrs) were loaded to induce fracture. Vertebroplasty was performed so that one of each pair was injected with Cortoss, the other with Spineplex. Specimens were then creep loaded at 1.0kN for 2 hours. At each stage of the experiment, stress” profiles were obtained by pulling a pressure-sensitive needle through the disc whilst under 1.5kN load. From these profiles, the intradiscal pressure (IDP), posterior stress peaks (SPP), and neural arch compressive load (FN) were determined. BMD was measured using dual photon X-ray absorptiometry. Severity of fracture was quantified from height loss.
Results: Fracture reduced IDP (p< 0.001) but increased SPP and FN (p< 0.001). Following vertebroplasty, these effects were significantly reversed, and in most cases persisted after creep-loading. However, no differences were observed between PMMA- and Cortoss-injected specimens. After fracture, decreases in IDP, and increases in SPP and FN, were greater in specimens with lower BMD or greater height loss (p< 0.05). After vertebroplasty, specimens with lower BMD showed greater increases in IDP, and those with more degenerated discs showed greater reductions in SPP (p< 0.05).
Conclusions: Changes in spinal load-sharing following fracture were partially restored by vertebroplasty, and this effect was independent of cement type. The effects of fracture and vertebroplasty were influenced by BMD, disc degeneration, and fracture severity. People with more severe fractures, low BMD and degenerated discs may gain most mechanical benefit from vertebroplasty.
Correspondence should be addressed to: Mr John O’ Dowd, SBPR, c/o BOA, The Royal College of Surgeons, 35–43 Lincoln’s Inn Fields, London WC2A 3PE.
