Abstract
The choice to use alumina in the manufacture of a low-wear THR bearing made by Boutin and its co-workers has proven its effectiveness in almost 35 years of clinical use. A continuous development process aimed to improve mechanical properties led to today’s materials that exhibit extreme high reliability.
The recent introduction in clinical use of alumina matrix composites represents the latest evolution of alumina that thanks to high hardness, toughness, and bending strength allow to manufacture new design of ceramic components. Composites obtained introducing zirconia in the alumina matrix, known as Zirconia Toughened Alumina (ZTA) are candidate for use in THA bearings from a long time. A real breakthrough was represented by alumina ceramics toughened both by zirconia both by platelets nucleated in-situ during sintering (Zirconia-Platelet Toughened Alumina - ZPTA).
The chemical composition and the microstructure of ZPTA were optimised to achieve a ceramic material joining strength of more than 1200MPa, Vickers hardness 1975, fracture toughness of 6,5 MPa m-1/2, andextremely low wear also in the most severe simulator tests performed in microseparation mode The paper reviews the improvements introduced in the technology of ceramic for arthoplasty, and their effects on the microstructural properties and on the performances of the past and actual generation of ceramic for THR bearings, and summarise the results obtained in the development of alumina matrix composites.
Correspondence should be addressed to Richard Komistek, PhD, International Society for Technology in Arthroplasty, PO Box 6564, Auburn, CA 95604, USA. E-mail: ista@pacbell.net
