ANTERIOR FEMORAL NOTCHING DURING TOTAL KNEE ARTHROPLASTY: A FINITE ELEMENT ANALYSIS

Abstract

Notching of the anterior femoral cortex during total knee arthroplasty is thought to be a possible risk factor for subsequent periprosthetic femoral fracture. Understanding the stress pattern caused by notching may help the orthopedic surgeon reduce the risk of fracture. A validated, three dimensional, finite element model of the femur using gait loads has been used to analyze the stress concentrations caused by anterior femoral cortex notching. Three factors that increase these stresses were identified. The notch depth, radius of curvature, and its proximity to the end of the femoral prosthesis influence the state of stress in the surrounding bone.

The purpose of this study was to characterize the stress concentration caused by anterior femoral notching during total knee replacement (TKR) in order to determine when a patient is at risk for a periprosthetic fracture of the femur.

We concluded that notches greater than 3 mm with sharp corners located directly at the proximal end of the femoral implant produced the highest stress concentrations and may lead to a significant risk of periprosthetic femur fracture.

One complication that can occur during TKR is notching of the anterior femoral cortex which results in a stress concentration. It is important to characterize this stress riser in order to determine when a stemmed femoral component should be used to minimize the risk of fracture.

Three factors that affected the stress concentration were identified. First, increasing the notch depth lead to significant increased stress concentrations. When the depth was greater than 3 mm, local stresses increased markedly. Second, the radius of curvature was found to be inversely related to stress concentration. As the radius decreased, the local stress increased. Third, the proximity of the notch to the prostheses affected the stress concentration. Notches that were 1 mm proximal to the implant resulted in much larger stresses than those that were 10 mm away.

A validated, three dimensional finite element model of a femur subjected to a gait loading pattern was used to characterize the stress concentration caused by anterior femoral notching. The results compared well to previous work reported in the literature.