EARLY RESULTS OF A TRABECULAR METAL TIBIAL COMPONENT IN TOTAL KNEE REPLACEMENT

Abstract

Introduction We report the early results of a series of 80 primary total knee replacements (TKRs) using a trabecular metal tibial component (TMT).

Methods Significant tibial bone loss and scarcity of kit were the only reasons for patients not receiving a TMT. Age, sex, diagnosis and body mass index (BMI) were recorded. Patients were scored pre-operatively using the Oxford Knee and SF-12 scores. These were repeated at subsequent clinical follow up where standard X-rays were also taken. Range of movement was estimated using a goniometer and stability assessed clinically. This regimen was identical to that in place for the standard knee previously used by the senior author with a cemented tibial component and this group is used in comparison as possible.

Results To date there are 80 TMT knees in the series with 36 standard cemented TKRs in comparison. The mean age of the whole series is 70 years (20–90) with no difference between the groups. Sixty five per cent of the series were female. All bar three patients had osteoarthritis. The mean BMI was 30.3 (20.9–46.2). The mean pre-op Oxford score was 45.8 in the TMT group and 44.5 in the cemented group. At a mean follow up of 13.3 (9–17) months in the TMT group and 18.7 (9–19) months in the cemented group this fell to 22.5 and 20.5 respectively. The physical component of the SF-12 score improved from 27.3 to 40.7 in the TMT group and from 27.5 to 45.5 in the cemented group. There was no statistical difference between the groups using either score. The mean amount of flexion pre-operatively was 106 (65–135) degrees for the series. This was maintained postoperatively at 105 degrees (70–125) with no difference between the groups. There was one deep infection in the cemented group that underwent revision and one non-fatal pulmonary embolus in the cemented group. There were no worrying radiological signs in either group.

Conclusion Trabecular metal is made from elemental tantalum. The TMT is an uncemented component with a truly porous structure for bone ingrowth and a modulus of elasticity equivalent to bone that allows physiological transfer of stresses. The early clinical and radiological results are equal to a cemented prosthesis. Further follow up is required to see whether this is maintained over time.