Abstract
Objective: To emphasize the need to provide a controlled method of intra-operative reduction to correct fixed cervical flexion deformities in ankylosing spondylitis and to describe the technique involved.
Design: The treatment of severe fixed cervical flexion deformity in ankylosing spondylitis represents a challenging problem that is traditionally managed by a corrective cervicothoracic osteotomy. The authors describe a method of controlled surgical reduction of the deformity, which eliminates saggital translation and reduces the risk of neurological injury.
Subjects: 2 male patients aged 39 and 45 years old with ankylosing spondylitis presented with severe fixed flexion deformity of the cervical spine. Both patients had previously undergone a lumbar extension osteotomy to correct a severe thoracolumbar kyphotic deformity. As a result of the fixed cervical flexion deformity, marked restriction in forward gaze with ‘chin on chest’ deformity, feeding difficulties and personal hygiene were encountered in both. Their respective chin-brow to vertical angle was 60 and 72°. Somatosensory and motor evoked potentials were used throughout surgery. A combination of cervical lateral mass screws and thoracic pedicle screws were used. Interconnecting malleable rods were then fixed at the cervical end, thereby allowing them to slide through the thoracic clamps thus achieving a safe method of controlled closure of the cericothoracic osteotomy. When reduction was achieved, definitive pre-contoured titanium rods were interchanged. Halo-jacket was not considered necessary in view of the segmental fixation used.
Results: Good anatomical reduction was achieved, with near complete correction of the deformities, restoration of saggital balances and forward gazes. There were no neurological deficits in either patient and the postoperative recoveries were uneventful. Both osteotomies united with no deterioration noted at 2 years.
Conclusions: We illustrate a controlled method of surgical reduction during corrective cervicothoracic osteotomy of fixed cervical kyphosis in ankylosing spondylitis. This has been achieved with the use of a combination of cervical lateral mass screws and thoracic pedicle screws with interconnecting malleable rods that were later replaced with titanium rods. The authors believe that the unique technique described remains a technically demanding but adequate and safe approach for correcting such challenging deformities.
The abstracts were prepared by Mr Peter Millner. Correspondence should be addressed to Peter Millner, Consultant Spinal Surgeon, Orthopaedic Surgery, Chancellor Wing, Ward 28 Office Suite, St James’ University Hospital, Beckett Street, Leeds LS9 7TF.
